Aqua Primer Sealer Undercoat

METHOD:
Roller or brush

THEORETICAL COVERAGE:
Approx. 10-11 m² / litre depending on surface texture, substrate porosity and method of application

DRYING TIME:
Surface Dry – 30 minutes at 30°C
Hard Dry – 2 hours at 30°C

OVERCOATING TIME:
Minimum 2 hours under normal conditions

New or unpainted interior and exterior masonry surfaces:
a) Remove all imperfections and sand down for an even surface
b) Remove dust, contaminants or foreign matter with damp cloth
c) Allow surface to dry

Previously painted interior and exterior masonry surfaces:
a) Remove any loose, peeling or flaking paint using scrapper or water jet wash whichever is suitable
b) Repair any imperfections. Fill cracks with suitable water-resistant putty or filler and sand down to an even surface
c) Remove dust, contaminants or foreign matter with damp cloth
d) Remove oil or grease by solvent cleaning or mild detergent. Allow surface to dry
e) If fungus, moss or mould is visible, use Anti-Fungus Solution to treat the affected surface. Leave solution for at least 2 hours
f) Ensure that the previously painted surface is sound
g) If surface has a high gloss or semi-gloss finish, sand to remove the high gloss to enable the new paint to adhere

New or unpainted dressed or raw exterior timber:
a) Remove all imperfections and sand for a smooth surface
b) Fill nail holes with a suitable, exterior grade water-resistant wood filler
c) Remove dust and contaminants

Metal surfaces:
a) Thoroughly degrease and clean new metal surfaces (e.g. galvanized iron) to remove oil or other contaminants using suitable cleaning solvent
b) Allow to dry

For other metal surfaces which has rusted (e.g. mild steel), clean with abrasive cloth to remove rust. Do not use steel wool. Use suitable cleaning solvent to remove traces of impurities and contaminants before applying a coat of suitable primer. Under non-aggressive indoor conditions, the product can be used directly on clean metal surfaces. Otherwise, apply a coat of Crystalux A/C Primer on the well-prepared
surfaces

Plastic surfaces:
a) Thoroughly degrease and clean new surfaces to remove oil or other contaminants using suitable cleaning agent.
b) Light sanding is recommended to enhance adhesion.